New rear valance welded on and sanded..

Before shot of the driver side b post area, the bottom looked even worse..notice the rot just above the post under the roof..

New B post e coated and welded in place. While the old poast was removed, the rust damage between the top of the post and the roof was repaired.. same on both driver and passenger side.

Starting to look like a MGA again...

More problems uncovered bt the blaster..that welding mess on the bottom are my welding skills!

Front shot with the fenders attached. Cell phone camera does not do justice to how good it looks.

Finished repair on the rigth side body.

Swiss cheese section cut off

Same side, the top of the area was also damaged, this area must have had pounds of bondo. The entire length where the fender bolts to the body was pitted badly as well.

Close up of the damaged section.

Repaired nose and flange area.

Photo of the right front wreck damage from who knows when..the frame had some damage also, I assume from this smack.

Good photo showing the repair work done on the drivers door frame. New door skin is going on this one also.

Work completed on the right rear fender..new passenger door skin also visible.

Inside of the reskinned door, the door frame has been e-coated.

New door skin from VB being fit,
it required some "adjustment" but still much better than the old skin.

New piece welded into the nose,
this was the only way to fit a grill. The measurements side to side were off by 1/8 ince. Most likely from the
left side front wreck damage.

Before

After..the area around the truck had rusted badly, this is the corner radius..

More inner fender repair...

Side view, its starting to look like a car again, the gaps and lines liik really good.

Before..this area rusted badly..

After.. this is the same front hood opening, it was rusted and pitted badly, a new section was made and welded in.

Close-up of the repair.